Vrhunska željeznica šiljci proizvođač-GNEE

Kako do instalirati željeznica šiljci
Bolt spikes are a common railway turnout accessory that are često seen on railways. The role of bolt spikes also very important. In fact, there are many types of road spikes. In addition to bolt road spikes, there are other types. If divided IP to material, road spikes can be divided into into Cast Aluminum Spikes, Plastic Spikes, CERAMICS, Glass Spikes, Reflective Spikes, etc. Different types of road studs have different characteristics and can be used in different situations.
1. Place and install safety isolation facilities. This is a a very important point. I hope everyone cannot ignore it. During the entire dynamic construction process, whether it is a a new road or a road that has opened to traffic, everyone should be in the safety facilities. If the construction is on a road open to traffic, the ratio of safety personnel to installation personnel should be 1:1. For konstrukcija on on non-traffic sections, the ratio of safety personnel to installation personnel should be 1:3.
2. Determine the installation location and ensure that the installation location is flat. For pavement with expansion, cracks and unevenness, the pavement must be smoothed advance.
3. Clean the installation location with a brush and make sure the installation location is dry. Take an appropriate amount of glue and apply it evenly on the road studs.
4. Pritisnite the road spike tight on the installation position and ensure that the direction is correct. If there is too much glue, be sure to clean it; if it a cast aluminij footed road spike, make sure that the hole -depth is 1cm greater than the nail foot depth and the hole promjer 2mm veće than the nail foot promjer.
5. An inspekcija treba biti provedeno within two hours after the road studs are installed to ensure that all road studs are not installed backwards, crooked or crooked. After the road studs have cured for 4 hours, remove and install the isolation facilities.
Željeznica šiljci are podijeljeni na dva tipovi: ručni šiljci i mehanički šiljci. It is ručno izrađeno i has razni izgled i dimenzije, but the price is low and is općenito shipped by ton. Mechanical nails are made by machines through kovanje, toplina tretman, žica rukavi i drugi procesi. In addition, by interpreting the above information, you can also clearly understand that installing road studs is not a complicated matter, but it requires attention to many details. And this information will directly affect the application effect and service life of the road stud.